A simple looking card today again from my shows earlier this week. This is one I demoed so I hope you caught the shows to see how this card was done as sometimes it's really hard to write instructions.
Here I go, lol, I stared by cutting the configurations die twice in lilac card I then cut a strip of the lilac card at 11cm wide by whatever length you want. I then glued the adornments to either end of the strip. Next I cut 2 more of the configurations from coconut white card and cut a narrower strip of coconut white at 9cm. I cut the adornments down to the same width ( there is a natural place to do this) and attached these to the top and bottom of the white strip.
For the front panel I die cut the two scribble flowers with stems form a smaller piece of the coconut white card. I carefully attached a piece of double sided adhesive to the back before removing the die and took out the die cut flowers leaving a negative of the flower showing., I added a spice of lilac card and covered the negative space with diamond sprinkles adding a pearl in the centre of each flower.
I made up the card as shown using a panel of checker board embossing at the back along with some layers of the lilac and white.
A bow and a sentiment and finished the card with a few more pearls ( of course)